[hts-users:01959] Re: How to configure HTS with STRAIGHT when using a different sampling rate?
Hi,
What hertz were original speech signals were sampled at?
What tool did you use for down-sampling to 22050Hz?
How about 32kHz?
Regards,
Keiichiro Oura
康世胤 wrote:
> hi
>
> I have build a voice by straight hts at 16Khz using the following param
> , and the voice is good.
>
> SAMPFREQ = 16000
> FRAMESHIFT = 80
> FREQWARP = 0.42
> GAMMA = 0
> MGCORDER = 39
> MGCLSP = 0
> LNGAIN = 1
>
>
>
> Now I am trying to build a voice at 22khz.
> The following parameters are applied when configure, but I got a very
> bad voice.
>
> SAMPFREQ = 22050
> FRAMESHIFT = 110
> FREQWARP = 0.45
> GAMMA = 0
> MGCORDER = 39
> MGCLSP = 0
> LNGAIN = 1
>
>
> Should I change some other param to meet the new sampling rate ?
> I have searched the mail list,
> and found that the mgc order should also be changed when using a
> differen sampling rate in hts without straight.
>
> So, should it be changed in straight hts?
> Is there a recommended value at 22khz?
> Is this value OK?
> mgcorder = 39 / 16k * 22k = 53
>
>
>
>
> --
> 康世胤
> Shiyin Kang
>
- Follow-Ups
-
- [hts-users:01960] Re: How to configure HTS with STRAIGHT when using a different sampling rate?, 康世胤
- References
-
- [hts-users:01958] How to configure HTS with STRAIGHT when using a different sampling rate?, 康世胤