I tried HHEd in HTS-2.2beta in this way:
1. Use a question set including only one question that I wanted to set as the root node to cluster a initial tree, which I got:
QS A0_0_TYPE=EN { ...... }
{*}[2]
{
0 A0_0_TYPE=EN "mgc_s2_2" "mgc_s2_1"
}
......
This is the resulting tree file.
2. Then I tried HHEd with -q option and a full version of question set. I added a LT command before TB to load the initial tree. And the -q value is set to 2. Then I make voice.
However, the resulting tree was exactly the same as the initial tree above. Do I used the -q option in a wrong way or the value is not appropriate?
The top node question is not included in the full question set.
Please inform me about how to use the -q option of HHEd. Thanks!
At 2011-04-19 23:03:24,"Keiichiro Oura" <uratec@xxxxxxxxxxxxxxx> wrote: >Hi, > >HHEd in HTS-2.2 beta can do it with '-q' option. >Before TB command, LT command can be used. > >Regards, >Keiichiro Oura > > >2011/4/19 那兴宇 <nxy-yzqs@xxxxxxx>: >> Hi, all >> >> I want to set a specified question to be used in the root node of the state >> decision tree. Which edit command of HHEd should I use? If there is none, >> how should I do with the current version to specify a root node question? >> Please give some suggestions, thanks! >> -- >> Na Xingyu >> Beijing Institute of Technology >> >> ________________________________ >> 体验网易邮箱2G超大附件,轻松发优质大电影、大照片,提速3倍! >